The Axial SCX24 Servo mount w/ upper-link risers from Dinky R/C, allow for increased adjustability, and can be used on your front & rear axles. Our servo mount is designed to fit the slightly larger Emax branded servos, or similar upgrade models, while retaining the factory suspension mounting location for use when installed on your front axle. The servo mounting tabs have been thoughtfully designed to have better clearance during articultion, when using the factory frame rails. Suggested trimming of your servos mounting "ears" to match the servo mounts shape, will all but eliminate the inherent rubbing that occurs with the stock setup. Additionally, this servo mount can be installed on the rear axle, in order to utilize the upper-link riser mounting positions, for increased climbing ability. The larger vertical separation of the rear axles upper and lower mounting points provides increased mechanical traction, imposing more downward force onto the chassis when under load. Giving you more forward grip while climbing, without the need for adding additional weight to your rig.
These small suspension geometry changes can dramatically affect your rigs anti-squat and anti-dive characteristics. As well as increasing your climbing angle ability compared to the stock setup. Video below shows 3° of increased climbing ability, when compared to using stock components. The raw chassis'd OEM Jeep Gladiator topped out at 57° before fipping off the test ramp, while the Dinky R/C modified rig topped out at a solid 60°, finally tapping outat 61°. Both rigs were running identical setups, only difference is our suspension mounts, and the repositioning of the upper-links front & rear.
(Servo mount has identical rear upper-link mounting positions as the basic rear upper-link mount used in the test video, so the same performance can be expected)
Designed and manufactured "in-house", and meticulously 3d printed to give you more "bang for your buck", while providing noticeable performance gains!
Servo mount w/Rear upper-link riser (1pc)
(Hardware NOT included)
***3-link version installs using factory hardware***
*** 4-link version Requires (2) 1.4mm x 8mm hardware***